Volvo L120F Wheel Loader Service Parts Catalogue Manual INSTANT (SN: 23004 and up, 66401 and up, 71701 and up)

Service Information Document Title: Function Group: Information Type: Date: Cab, removing 810 Service Information 2014/5/8 0 Profile: WLO, L120F [GB] Go back to Index Page Cab, removing Op nbr 810-001 14360000 Vacuum pump / 24V 88830070 Plug 88830070 Plug 88830070 Plug 88830070 Plug 88830070 Plug 88830070 Plug 88830070 Plug 88830070 Plug 88830070 Plug 88830070 Plug Sling 4 m (13 ft), 2 pcs. Lifting eye M16, 4 pcs. Shackle 4 pcs. Hose pliers, 4 pcs NOTE! Do not loosen any hoses or connections for the air conditioning, as this will lead to accidental release of refrigerant. Figure 1 1. 2. Squib cable (gas generator cable) Electric power cable

1. Place the machine in service position 1, see . 191 Service position 2. Disconnect the (red) electric power cable and squib cable (gas generator cable) from the control unit to deactivate the fire suppression system. 3. Remove the front part of the rear fender on the machine's right and left side. Weight, approx. 35 kg (80 lbs). Remove the cover plate behind the front part of the rear fender on the machine's right side. Figure 2 1. Front part of rear mudguard 4. Part the washer fluid hoses by the non-return valves. Figure 3 1. Junction pieces washer fluid 5. Remove the plastic casing together with the air filters. Remove the plate and unplug the connector for the recirculation damper, MO8703.

Figure 4 1. Connector 6. Unplug the connector for the pressure monitor, SE8709, and cut the cable ties. Pull out the hose from the cab's temperature sensor. Remove the sealing strip and the protective plate. Loosen the bolt for the clamp. Press out the plastic on the right side of the evaporator so that the lug on the evaporator releases. Swing out the attaching plate together with the evaporator and lay it on the steps. Figure 5 1. 2. 3. 4. 5. 6. 7. Hose from cab's temperature sensor Connector recirculation damper Attaching plate Sealing strip Protective plate Connector for pressure monitor SE8709 Clamp 7. Remove the protective casing located over the cable harnesses at the back to the left on the cab wall. Disconnect the electrical terminals and detach the belt retaining the cable harness.

8. If the machine is equipped with rear vision camera: [ 1]  Remove the cover plate in front of the engine cover. Disconnect the cable from rear vision camera. Cut the ties keeping the cable harness together at the rear vision camera. Pull out the cable by the cab, bundle together in a suitable way and attach to the cab. 9. Clamp the coolant hoses with the aid of hose pliers. Disconnect the coolant hoses from the cab. Figure 6 1. 2. Pause heat pump [ 2]  Coolant hoses 10. Remove the cover plates by the cab's bottom part on the machine's right and left side. [ 3]  11. Install a wedge under the steering valve so that it does not fall down when the attaching bolts are removed. Figure 7

You're Reading a Preview

Volvo L120F Wheel Loader Service Parts Catalogue Manual INSTANT (SN: 23004 and up, 66401 and up, 71701 and up)

Description

Reviews

Q&A

Recently Viewed