2008 SUZUKI RENO All Models Service and Repair Manual

NUBIRA/LACETTI SERVICE NOTICE 0–1 FOREWORD This manual includes procedure for maintenance, adjustment, service operation and removal and installation of components. All information, illustrations and specifications contained in this manual are based on the latest product information available at the time of manual approval. The right is reserved to make changes at any time without notice.

0–2 SERVICE NOTICE NUBIRA/LACETTI SECTION 0 SERVICE NOTICE CONTENTS 1. HOW TO USE THIS MANUAL 0 – 3 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2. SPECIAL INFORMATION 0 – 3 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3. SUPPLEMENTAL RESTRAINT SYSTEM (SRS) 0 – 4 . . . . . . . . . . . . . . . . . . . . . . . .

NUBIRA/LACETTI SERVICE NOTICE 0–3 1. HOW TO USE THIS MANUAL . This manual covers the repairs of NUBIRA/LACETTI automobile which has been involved in accidents, and it describes the work related to the replacement of damaged body parts. Please read through these instructions and familiarize yourself with them before actually using this manual. . Note : Refer to NUBIRA/LACETTI Service Manual for specifications, wire harness locations, safety stand sup- port points, etc. 2. SPECIAL INFORMATION . Indicates a strong possibility of personal injury or equip- ment damage if instructions are not followed. . Note : Gives helpful information. . CAUTION : Detailed descriptions of standard work- shop procedures, safety principles and service op- erations are not included. Please note that this manual does contain warnings and cautions against some specific service methods which could cause PER- SONAL INJURY, or could damage a vehicle or make it unsafe. Please understand that these warnings can- not cover all conceivable ways in which service, whether or not recommended by GM DAEWOO might be done or of the possible hazardous consequences of each conceivable way, not could GM DAEWOO in- vestigate all such ways. Anyone using service procedures or tools, whether or not recommended by GM DAEWOO, must satisfy himself thoroughly that neither personal safety or tools, whether or not recommended by GM DAEWOO, must satisfy himself thoroughly that neither personal safety or vehicle safety will be jeopardized. . All information contained in this manual is based on the latest product information available at the time of print- ing. We reserve the right to make changes at any time without notice. No part of this publication may be repro- duced, stored in retrieval system, or transmitted, in any form by any means, electronic, mechanical, photocopy- ing, recording, or otherwise, without the prior written permission of the publisher. This includes text, figures and tables.

0–4 SERVICE NOTICE NUBIRA/LACETTI 3. SUPPLEMENTAL RESTRAINT SYSTEM (SRS) . The following precautions should be observed when performing sheet metal work, paint work and repair work around the locations of the SRS parts. . 1. SDM(Sensing and Diagnosis Module) are located under the center console ass’y. Avoid strong impact with ass’y hammer or other tools when repairing the front side frame and the lower part of the dashboard. Do not apply heat to these areas with a gas burner, etc. 2. SRS harness is located under the lower part of the dashboard below the dashboard panel. (SRS harness is covered with a yellow corrugated tube.) Care should be taken not to damage the harness when repairing this area. 3. Do not apply heat of more than 80°C (176°F) when drying painted surfaces anywhere around the locations of SRS parts. 4. If strong impact or high temperature needs to be ap- plied to the areas around the locations of SRS parts, re- move the part before performing repair work. 5. If any of the SRS related parts is damaged or de- formed, be sure to replace it. . Note : Refer to the Service Manual(Supplemental Re- straint System) for removal and replacement of SRS related parts.

BODY REPAIR MANUAL (NUBIRA/LACETTI) ISSUED BY SERVICE ENGINEERING TEAM GM DAEWOO AUTO & TECHNOLOGY CO., LTD. 199–1 CHONG CHON–DONG, PU PYUNG–GU, INCHON, KOREA TELEPHONE : 82–32–520–2737,2064 FACSIMILE : 82–32–520–4808

You're Reading a Preview

2008 SUZUKI RENO All Models Service and Repair Manual

Description

Reviews

Q&A

Recently Viewed