010-2
How to Use This Manual
WARNING!
Your common sense and good
judgment are crucial to safe and
successful service work. Read
procedures through before starting
them. Think about whether the
condition of your car, your level of
mechanical skill, or your level of
reading comprehension might result
in or contribute in some way to an
occurrence that might cause you
injury, damage your car, or result in
an unsafe repair. If you have doubts
for these or other reasons about your
ability to perform safe repair work on
your car, have the work done at an
authorized BMW dealer or other
qualified shop.
The manual is divided into ten sections:
0 GENERAL DATA AND
MAINTENANCE
1 ENGINE
2 TRANSMISSION
3 SUSPENSION, STEERING AND
BRAKES
4 BODY
5 BODY EQUIPMENT
6 ELECTRICAL SYSTEM
7 EQUIPMENT AND
ACCESSORIES
General http://ebahn.bentleypublishers.com/BMW/3/E46/Repair%20Manuals/0...
1 of 5 2/25/2009 10:07 PM
ELE ELECTRICAL WIRING
DIAGRAMS
OBD ON BOARD DIAGNOSTICS
0 GENERAL DATA AND
MAINTENANCE covers general vehicle
information (Repair Group 010) as well
as the recommended maintenance
schedules and service procedures to
perform BMW scheduled maintenance
work (Repair Group 020).
The next seven sections (Repair
Groups 1 through 7) are repair based
and organized by three digit repair
groups. Most major sections begin with
a General repair group, e.g. 100
Engine–General. These “00” (double
zero) groups are mostly descriptive in
nature, covering topics such as theory
of operation and troubleshooting. The
remainder of the repair groups contain
the service and repair information. The
last two major sections contains
detailed electrical wiring schematics
and scan tool codes.
A master listing of the individual repair
groups can be found on the inside
front cover. A comprehensive index can
be found at the back of the manual.
Warnings, cautions and notes
Throughout this manual are many
passages with the headings
WARNING, CAUTION, or NOTE. These
very important headings have different
meanings.
WARNING!
The text under this heading warns of
unsafe practices that are very likely
to cause injury, either by direct
threat to the person(s) performing
General http://ebahn.bentleypublishers.com/BMW/3/E46/Repair%20Manuals/0...
2 of 5 2/25/2009 10:07 PM
the work or by increased risk of
accident or mechanical failure while
driving.
CAUTION!
A caution calls attention to important
precautions to be observed during
the repair work that will help prevent
accidentally damaging the car or its
parts.
Note:
A note contains helpful information, tips
that will help in doing a better job and
completing it more easily.
Please read every WARNING,
CAUTION, and NOTE at the front of
the manual and as they appear in
repair procedures. They are very
important. Read them before you begin
any maintenance or repair job.
WARNING!
Never run the engine in the work
area unless it is well-ventilated.
The exhaust should be vented to
the outside. Carbon monoxide
(CO) in the exhaust kills.
Remove all neckties, scarfs,
loose clothing, or jewelry when
working near running engines or
power tools. Tuck in shirts. Tie
long hair and secure it under a
cap. Severe injury can result
from these things being caught
in rotating parts.
Remove rings, watches, and
bracelets. Aside from the
dangers of moving parts,
metallic jewelry conducts
electricity and may cause
General http://ebahn.bentleypublishers.com/BMW/3/E46/Repair%20Manuals/0...
3 of 5 2/25/2009 10:07 PM
shorts, sparks, burns, or
damage to the electrical system
when accidentally contacting
the battery or other electrical
terminals.
Disconnect the battery negative
(–) cable whenever working on
or near the fuel system or
anything that is electrically
powered. Accidental electrical
contact may damage the
electrical system or cause a fire.
Fuel is highly flammable. When
working around fuel, do not
smoke or work near heaters or
other fire hazards. Keep an
approved fire extinguisher
handy.
The fuel system is designed to
retain pressure even when the
ignition is off. When working
with the fuel system, loosen the
fuel lines slowly to allow the
residual pressure to dissipate
gradually. Take precautions to
avoid spraying fuel.
Illuminate the work area
adequately and safely. Use a
portable safety light for working
inside or under the car. A
fluorescent type light is best
because it gives off less heat. If
using a light with a normal
incandescent bulb, use rough
service bulbs to avoid breakage.
The hot filament of an
accidentally broken bulb can
ignite spilled fuel or oil.
Keep sparks, lighted matches,
General http://ebahn.bentleypublishers.com/BMW/3/E46/Repair%20Manuals/0...
4 of 5 2/25/2009 10:07 PM
and any open flame away from
the top of the battery. Hydrogen
gas emitted by the battery is
highly flammable. Any nearby
source of ignition may cause the
battery to explode.
Never lay tools or parts in the
engine compartment or on top
of the battery. They may fall into
confined spaces and be difficult
to retrieve, become caught in
belts or other rotating parts
when the engine is started, or
cause electrical shorts and
damage to the electrical system.
Copyright © 2006 Robert Bentley, Inc. All rights reserved.
General http://ebahn.bentleypublishers.com/BMW/3/E46/Repair%20Manuals/0...
5 of 5 2/25/2009 10:07 PM
010-3
Getting Started
Most of the necessary maintenance
and minor repair that an automobile will
need can be done with ordinary tools.
Below is some important information on
how to work safely, a discussion of
what tools will be needed and how to
use them.
Safety
Although an automobile presents many
hazards, common sense and good
equipment can help ensure safety.
Many accidents happen because of
carelessness. Pay attention and stick
to safety rules in this manual.
Lifting the car
The proper jacking points should be
used to raise the car safely and avoid
damage. The jack supplied with the car
can only be used at the four side
points (arrows)—just behind the front
wheels or just in front of the rear
wheels.
WARNING!
Never work under a lifted car
unless it is solidly supported on
jack stands that are intended for
that purpose.
When raising the car using a
floor jack or a hydraulic lift,
carefully position the jack pad to
prevent damaging the car body.
Plastic pads are provided for
this purpose by the
manufacturer at the jacking
General http://ebahn.bentleypublishers.com/BMW/3/E46/Repair%20Manuals/0...
1 of 4 2/25/2009 10:07 PM
points.
Watch the jack closely. Make
sure it stays stable and does not
shift or tilt. As the car is raised,
it may roll slightly and the jack
may shift.
Raising car safely
- Park car on flat, level surface.
- If changing a tire, loosen lug bolts
before rasing car. See
Changing a tire .
Place jack into position. Make sure jack
is resting on flat, solid ground. Use a
board or other support to provide a firm
surface for the jack, if necessary
- Raise car slowly while constantly
checking position of jack and car.
- Once car is raised, block wheel
that is opposite and farthest from
jack to prevent car from
unexpectedly rolling.
WARNING!
Do not rely on the transmission
or the emergency brake to keep
the car from rolling. They are
not a substitute for positively
blocking the opposite wheel.
Never work under a car that is
supported only by a jack. Use
jack stands that are designed to
support the car. See Tools .
General http://ebahn.bentleypublishers.com/BMW/3/E46/Repair%20Manuals/0...
2 of 4 2/25/2009 10:07 PM
Working under car safely
- Disconnect negative (–) cable from
battery so that no one can start
car. Let others know what you will
be doing.
CAUTION!
Prior to disconnecting the battery,
read the battery disconnection
cautions given at the front of this
manual on page viii.
- Raise car slowly as described
above.
- Use at least two jack stands to
support car. Use jack stands
designed for the purpose of
supporting a car. For more
information on jack stands, see
Tools .
WARNING!
A jack is a temporary lifting
device and should not be used
alone to support the car while
you are under it.
Do not use wood, concrete
blocks, or bricks to support a
car. Wood may split. Blocks or
bricks, while strong, are not
designed for that kind of load,
and may break or collapse.
- Place jack stands on firm, solid
surface. If necessary, use a flat
board or similar solid object to
provide a firm footing.
General http://ebahn.bentleypublishers.com/BMW/3/E46/Repair%20Manuals/0...
3 of 4 2/25/2009 10:07 PM
- Lower car slowly until its weight is
fully supported by jack stands.
Watch to make sure that the jack
stands do not tip or lean as the
car settles on them.
- Observe all jacking precautions
again when raising car to remove
jack stands.
Copyright © 2006 Robert Bentley, Inc. All rights reserved.
General http://ebahn.bentleypublishers.com/BMW/3/E46/Repair%20Manuals/0...
4 of 4 2/25/2009 10:07 PM
You're Reading a Preview
What's Included?
Lifetime Access
Fast Download Speeds
Online & Offline Access
Access PDF Contents & Bookmarks
Full Search Facility
Print one or all pages of your manual
$37.99
2003 BMW X3-Series E83 Service and Repair Manual
Viewed 29 Times Today
What's Included?
Lifetime Access
Fast Download Speeds
Online & Offline Access
Access PDF Contents & Bookmarks
Full Search Facility
Print one or all pages of your manual
$37.99
Secure transaction
What's Included?
Lifetime Access
Fast Download Speeds
Online & Offline Access
Access PDF Contents & Bookmarks
Full Search Facility
Print one or all pages of your manual
Description
The 2003 BMW X3-Series E83 Service and Repair Manual is a comprehensive guide for maintaining and fixing your 2003 BMW X3. Whether you're a professional mechanic or a DIY enthusiast, this manual provides detailed instructions and diagrams to help you tackle any repair or service task.
Some of the key features of this manual include:
- Step-by-step instructions for all repairs, from basic maintenance to complex engine repairs
- Clear and easy-to-follow diagrams and illustrations
- Includes specifications, troubleshooting tips, and diagnostic information
- Covers all trim levels and engine options for the 2003 BMW X3-Series E83
- Provides detailed information on routine maintenance procedures, such as oil changes, brake replacements, and tire rotations
- Includes information on electrical systems, fuel systems, cooling systems, and more
With the 2003 BMW X3-Series E83 Service and Repair Manual, you can save time and money by performing your own repairs and maintenance. Whether you're a seasoned mechanic or a novice DIYer, this manual is an essential tool for keeping your BMW X3 running smoothly and efficiently.
