TO THE PURCHASER OF A CASE TRACTOR The care you give your new Case Tractor will greatly determine the satisfaction and Service life you will obtain from it. Use this manual as your guide. Byobservingtheinstructions and suggestions in this manual, your Case Tractor will serve you well. As an Authorized Case Dealer. we stock Genuine Case Parts. which are manufactured with the same precision and skill as the original equipment. Our factory trained staff is kept well informed on the best methods of servicing Case equipment and is ready and able to help you, Should you require additional aid or iuformation, contact us. HI FOLKSI-I'm Sammy Safety. Look for me to point out important Safety PrecautloM To insure efficient and prompt service, please furnish us with the Model, Serial and Engine Numbers of your Tractor in all cor- respondence or contacts. 1
Figure 1 Left Hand Side View of the Construction King Tractor with Hydrostatic Drive Figure 2 Right Hand View of the Construction King Tractor with Hydrostatic Drive 2
SERIAL NUMBER When ordering parts from your Authorized Case Dealer and in all contacts or correspondence with your dealer relative to the Tractor, always specify the Serial, Model and Engine Numbers of your Tractor. The Model and Serial Numbers are stamped on the number plate located on the right hand side of the instrument panel. See Figure 3. The Engine Number is stamped on aplatefastened to the right hand side of the engine below the starting motor, Figure 4. MODEL AND SERIAL NUMBER PLATE Figure 3 ENGINE SERIAL NUMBER PLATE Figure 4 NDTE The terms "Right Hand" and nLeftHand" whenever used in this manual apply to the tractor when facing in the direction the tractor will move in forward operation. For reference, fill in the Serial Number. Model Number and Engine Number of your Construction King Tractor in the spaces provided below. Model Number ---------------- Engine Number _______ _ 3
SPECIFICATIONS Oenaral -----------------------''CASE" Chamber Combustion- 4 - Valve-in-Head. Order --------------------------------------- 1-3-4-2 Bore -------------------------------------- Stroke --------------------------------------------- 4- Piston ------------------------------ 188 Cu. In. Ratio -------------------------------- 17.5 to 1 *Valve Clearance and ,014 (Hot) Sleeves ------------------------\Vet ------------------------------- 2100 RPM No Load W:nrerned -------------------- 2250 RPM Air Cleaner --------------------------------- Oil Bath Cold Weather Aid ---- Eleetrin Heater Manifold Fuel Recommendation ------------ No. 2 Diesel I~uel *Hot Are Made At Low Idle After the has At Thermostat Control For At Least Fifteen Minutes. Piston and Rods ---------------------------------------- 2 ----------------------------------- 1 Piston Pins ------------------------------- Full Rod Main Bearings Number of Main __ ""* ___ .._.,., ____ ~.... PrecisionStocl Aluminum Liners, -----------------------------------5 --------------------- Preeision Steel Aluminum Liners. 4
l!nglne Lubricating System Oil Pressure ----------------- 50 to 70 Lbs. (With Engine Warm and Operating at Fu1l Governed RPM). Type System ------------------------------- Gear Type Pump With Floating Intake Sereen. P'uel System Fuel Injection Pump ---------------------------Roosa- Master Fuel Injectors ------------------------------ (Long Stem Multi- Hole) C.A.V. Fuel Injectors Opening Pressure --------------------- 2250 PSI Fuel Transfer Pump ---------------------- Vane Type (Integral Part of Injection Pump). Governor ----------------------------- Mechanical, Flyweight, (Integral Part of Injection Pump). Primary Fuel Filter ---------------- Replaceable Element Type Final Filter --------------------------Replaceable Filter Type Fuel Gauge ---------------------------- Electrical, Located on Instrument Panel. Fuel Tank Water Trap and Drain ---------- Bottom of Fuel Tank Fuel Tank Capacity--------------------------- 22 U.S. Gallons 5
Cooling System Type of System ------------- Pressurized, Thermostat Controlled Radiator Pressure Cap ------------------------ Open at 4 Lbs. Pump -------------------- Impeller Type - Sealed Pre-Lubri- cated Bearings. Radiator --------------- Heavy Duty Tube and Fin Construction Thermostat------------ Starts to Open at 177* Fully Open at 202°F. Electrical System Battery ---------------- 1-12 Volt, Group Size 30H, Rated at 1.255 to 1.265 Specific Gravity, Dis- charge Rate 300 Amps at 0" F. Vol- tage drops to 9.2 after 10 seconds, Voltage drops to 1.0 Volt per cell after 4 minutes. Generator ---------------- 12 Volt, 2 brush, 25 amp. max.output Voltage Regulator ------------------- 12 Volt - Automatic Type Starting Motor --------------------- 12 Volt With Solenoid Switch Manifold Heater ------------------------ 12 Volt - 1200 Watt Headlights ---------------(2) 12 Volt -35 Watt Sealed Beam Rear Light ------------------- 12 Volt Sealed Beam Combination Tail and Flood Lamp. Fuse --------------------- 20 AMP - Light Circuit - In Panel Brakes Type ---------------------- Heavy Duty, Disc and Band Differ- ential Brakes. Brake Pedals -------------- Can Be Locked Together for Safe Road Travel or Operated Independ- ently for Steering Assistance. 6
This complete factory manual for the Case 580 Construction King Diesel Wheel Tractor with Hydrostatic Drive provides detailed instructions, diagrams, and illustrations based on the manufacturer's specifications. It is an operator's manual that covers various aspects of operating and maintaining the tractor.
Instant access - no waiting
Language: English
Format: PDF
Compatible with all versions of Windows, Mac, iOS, BB, Android, etc
Searchable, bookmarked, and indexed
Contents:
Serial numbers
Diesel engine specifications
General specifications including cooling system, electrical system, brakes, power train, draft-0-matic system, approximate weights, tires and pressures, and overall measurements
Fuel specifications and conditioner
Lubrication recommendations, capacities, and chart
Safety precautions including towing
Operating instructions, including run-in procedure, pre-starting checklist, operating controls and instruments, starting and stopping procedures, cold weather operation and starting procedure, operating tips, drawbar, and system adjustments
Preventive maintenance for various systems such as cooling, diesel fuel, differential brakes, and electrical
This manual is easy to read and can be viewed, zoomed, and printed on any computer. It is completely indexed, searchable, and bookmarked, with technical details and instructions included.
Additional Information: Some documents may require the newest version of Acrobat Reader to display correctly. Should you have any problems reading your document, please initially try upgrading to the latest version of Adobe Acrobat Reader.
For more information or other manuals, feel free to email for assistance.
Recently Viewed
5,521,897Happy Clients
2,594,462eManuals
1,120,453Trusted Sellers
15Years in Business
Price:
Actual Price:
1966-1971 Case 580 Construction King 580CK Tractor Owners Manual