Answer
Dec 05, 2024 - 03:47 PM
To reset the ECU on a Nissan X-Trail, you can use either the fuse method or the pedal method:
Fuse Method:- Turn off the engine and remove the key from the ignition.
- Open the hood and locate the ECU fuse box near the battery.
- Remove the ECU fuse and wait for approximately 10 seconds.
- Reinsert the ECU fuse securely and close the hood.
- Start the engine and let it idle for a few minutes.
- Turn off the engine and restart it to confirm the ECU reset.
- Turn the ignition to the "ON" position without starting the engine.
- Fully press and release the accelerator pedal five times within five seconds.
- Wait for seven seconds, then fully press the accelerator pedal and hold it for 10 seconds.
- Release the pedal and then press it fully again, holding for another 10 seconds.
- Turn the ignition off and then on to check if the ECU has been reset.
Resetting the ECU will clear adaptive settings and may erase error codes. It’s recommended to address any underlying issues before performing an ECU reset. If you're uncertain about these steps, consult your vehicle’s repair manual for specific instructions tailored to your model year.
